Obtaining the IP address for the IMMUse this information to obtain the IP address for the IMM.About this taskTo access the Web interface to use the remote presence feature, you need the IPaddress of the IMM. You can obtain the IMM IP address through the Setup utility.The server comes with a default IP address for the IMM of 192.168.70.125. To locatethe IP address, complete the following steps:Procedure1. Turn on the server.Note: Approximately 1 to 3 minutes after the server is connected to ac power,the power-control button becomes active.2. When the prompt Setup is displayed, pressF1. (This prompt is displayedon the screen for only a few seconds. You must press F1 quickly.) If you haveset both a power-on password and an administrator password, you must typethe administrator password to access the full Setup utility menu.3. From the Setup utility main menu, select System Settings.4. On the next screen, select Integrated Management Module.5. On the next screen, select Network Configuration.6. Find the IP address and write it down.7. Exit from the Setup utility.Logging on to the Web interfaceUse this information to log on to the web interface.About this taskTo log on to the IMM Web interface, complete the following steps:Procedure1. Open a Web browser on a computer that connects to the server and in theAddress or URL field, type the IP address or host name of the IMM to whichyou want to connect.Note: If you are logging on to the IMM for the first time after installation, theIMM defaults to DHCP. If a DHCP host is not available, the IMM assigns astatic IP address of 192.168.70.125. The MAC address tag provides the defaulthostname of the IMM and does not require you to start the server.2. On the Login page, type the user name and password. If you are using theIMM for the first time, you can obtain the user name and password from yoursystem administrator. All login attempts are documented in the event log.Note: The IMM is set initially with a user name of USERID and password ofPASSW0RD (passw0rd with a zero, not a the letter O). You have read/writeaccess. You must change the default password the first time you log on.3. On the Welcome page, type a timeout value (in minutes) in the field that isprovided. The IMM will log you off of the Web interface if your browser isinactive for the number of minutes that you entered for the timeout value.4. Click Continue to start the session. The System Health page provides a quickview of the system status.Chapter 3. Configuration information and instructions 103
