Installation guidelinesUse the installation guidelines to install the System x3650 M4 BD Type 5466.Attention:v Static electricity that is released to internal server components when the server ispowered-on might cause the system to halt, which might result in the loss ofdata. To avoid this potential problem, always use an electrostatic-discharge wriststrap or other grounding system when removing or installing a hot-swap device.v This product is not intended to be connected directly or indirectly by any meanswhatsoever to interfaces of public telecommunications networks, neither to beused in Public Services Network.Before you install optional devices, read the following information:v Read the safety information that begins on page “Safety” on page vii and theguidelines in “Handling static-sensitive devices” on page 34. This informationwill help you work safely.v Make sure that the devices that you are installing are supported. For a list ofsupported optional devices for the server, go to http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/.v When you install your new server, take the opportunity to download and applythe most recent firmware updates. This step will help to ensure that any knownissues are addressed and that your server is ready to function at maximumlevels of performance. To download firmware updates for your server, go tohttp://www.ibm.com/support/fixcentral/.Important: Some cluster solutions require specific code levels or coordinatedcode updates. If the device is part of a cluster solution, verify that the latest levelof code is supported for the cluster solution before you update the code.For additional information about tools for updating, managing, and deployingfirmware, see the ToolsCenter for System x and BladeCenter athttp://www.ibm.com/support/entry/portal/docdisplay?lndocid=TOOL-CENTER.v Before you install optional hardware, make sure that the server is workingcorrectly. Start the server, and make sure that the operating system starts, if anoperating system is installed, or that a 19990305 error code is displayed,indicating that an operating system was not found but the server is otherwiseworking correctly. If the server is not working correctly, see “Running the DSAPreboot diagnostic programs” on page 129 for information about how to rundiagnostics.v Observe good housekeeping in the area where you are working. Place removedcovers and other parts in a safe place.v Do not attempt to lift an object that you think is too heavy for you. If you haveto lift a heavy object, observe the following precautions:– Make sure that you can stand safely without slipping.– Distribute the weight of the object equally between your feet.– Use a slow lifting force. Never move suddenly or twist when you lift a heavyobject.– To avoid straining the muscles in your back, lift by standing or by pushingup with your leg muscles.v Make sure that you have an adequate number of properly grounded electricaloutlets for the server, monitor, and other devices.v Back up all important data before you make changes to disk drives.32 System x3650 M4 BD Type 5466: Installation and Service Guide
