13. Slide the server in the rack.14. Reconnect the power cord and any cables that you removed.15. Turn on the peripheral devices and the server.Note: When you restart the server, you are prompted to import the existingRAID configuration to the new ServeRAID adapter.Removing an optional IBM ServeRAID-MR10is VAULT SAS/SATAControllerTo remove an IBM ServeRAID-MR10is VAULT SAS/SATA adapter, complete thefollowing steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 127.2. Turn off the server and peripheral devices and disconnect the power cords.Note: When you disconnect the power source from the server, you lose theability to view the LEDs because the LEDs are not lit when the power source isremoved. Before you disconnect the power source, make a note of which LEDsare lit, including the LEDs inside the server on the system board.3. Remove the cover (see “Removing the cover” on page 130).4. Remove the riser-card assembly (see “Removing the riser-card assembly” onpage 133).5. Disconnect the signal cable from the ServeRAID-MR10is VAULT SAS/SATAadapter.6. Carefully grasp the end of the ServeRAID adapter and pull it out of theconnector on the riser-card assembly.7. If you are instructed to return the ServeRAID adapter, follow all packaginginstructions, and use any packaging materials for shipping that are supplied toyou.Installing the optional IBM ServeRAID-MR10is VAULT SAS/SATAcontrollerThe optional IBM ServeRAID-MR10is VAULT SAS/SATA controller can be installedonly in its dedicated connector on the riser-card assembly. The ServeRAID-MR10isVAULT SAS/SATA adapter is supported on hot-swap server models only. The IBMServeRAID-MR10is VAULT SAS/SATA adapter with an encryption 1078 DE chip setenables integrated RAID levels 0, 1, 5, 6, and 10 support capability on hot-swaphard disk drives. For configuration information, see the documentation on theServeRAID CD that comes with the adapter.Important: To ensure that any of your ServeRAID adapters function properly onUEFI-based servers, make sure that the adapter firmware level is updated to atleast 11.xx-XXX, and the supporting drivers.Attention: Some cluster solutions require specific code levels or coordinated codeupdates. If the device is part of a cluster solution, verify that the latest level of codeis supported for the cluster solution before you update the code.To install the ServeRAID-MR10is VAULT SAS/SATA controller and route the cables,complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 127.162 IBM System x3250 M3 Types 4251, 4252, and 4261: Problem Determination and Service Guide