v Query power-supply input power.v PECI 2 support.v Power/reset control (power-on, hard and soft shutdown, hard and soft reset,schedule power control).v Alerts (in-band and out-of-band alerting, PET traps - IPMI style, SNMP, email).v Operating-system failure blue screen capture.v Command-line interface.v Configuration save and restore.v PCI configuration data.v Boot sequence manipulation.The IMM also provides the following remote server management capabilitiesthrough the OSA SMBridge management utility program:v Command-line interface (IPMI Shell)The command-line interface provides direct access to server managementfunctions through the IPMI 2.0 protocol. Use the command-line interface to issuecommands to control the server power, view system information, and identify theserver. You can also save one or more commands as a text file and run the fileas a script.v Serial over LANEstablish a Serial over LAN (SOL) connection to manage servers from a remotelocation. You can remotely view and change the UEFI settings, restart the server,identify the server, and perform other management functions. Any standard Telnetclient application can access the SOL connection.Using the embedded hypervisorThe VMware ESXi embedded hypervisor is available on server models that comewith an installed USB embedded hypervisor flash device. The USB flash devicecomes installed in the USB connector on the system board. Hypervisor isvirtualization software that enables multiple operating systems to run on a hostsystem at the same time. The USB flash device is required to activate thehypervisor functions.To start using the embedded hypervisor functions, you must add the USB flashdevice to the boot order in the Setup utility.To add the USB flash device to the boot order, complete the following steps:1. Turn on the server.Note: Approximately 1 to 3 minutes after the server is connected to ac power,the power-control button becomes active.2. When the prompt Setup is displayed, press F1.3. From the Setup utility main menu, select Boot Manager.4. Select Add Boot Option; then, select Embedded Hypervisor. Press Enter, andthen select Esc.5. Select Change Boot Order and then select Commit Changes; then, pressEnter.6. Select Save Settings and then select Exit Setup.204 IBM System x3250 M3 Types 4251, 4252, and 4261: Problem Determination and Service Guide