IDS X64 Installer Manual

Also see for X64: Training manual User manual User manual Installer manual Manual

Contents

IDS X64 Installer Manual Manual pdf 15 page image

Section: 4IDS X64 Installer Manual 700-398-02D Issued August 2010 154.2 Defaulting KeypadsTo default the ID of an individual keypad:1. Remove power to the keypad (or the whole panel if easier).2. Hold down the [1] and [3] keys simultaneously until the beep (for at least 3 seconds).3. Restore the power.4. Wait for three seconds and then release the keys (there will not be a beep).5. All the keypad LEDs will flash simultaneously indicating that the keypad has been de-registered4. Wait for five seconds and ensure that the Panel Status LED on the panel is flashing.5. Press the [#] key to allocate a new ID to the defaulted keypad. Keypad IDs are allocatedincrementally.6. The ID of any (correctly registered) keypad can be viewed in location 243 from the keypad ofinterest.To default the ID of ALL keypads:1. Enter a value of [3] into location 0.[INSTALLER CODE] [*] [0] [*] [3] [*]2. On pressing the final [*], wait a few seconds and ALL the keypad LEDs will begin flashing. (DoNOT press the [#] key at the end of this sequence, unless you wish the keypad you are using tobe registered in the first address).3. Re-enrol all keypads by pressing the [#] key on each keypad – in the CORRECT sequence toensure that keypad zone and partition allocation is as required by the user.5. Event LogA comprehensive log of the 1 000 most recent events is retained in the non-volatile EEPROM. The logmay be retrieved using the up/download software, or on the LCD keypad. (See the LCD Keypad Manualor User Manual to see how to view the event log).The IDS Download Software is available for Inhep account customers, at no cost, to collect your eventlogs via direct serial download, or via a modem.6. Access CodesThe panel supports up to 128 users. The user codes can have various properties assigned to them.These properties allow the user codes to have different functions.6.1 Normal User CodeA normal user code is used to arm/disarm the panel, and to access certain user options.6.1.1 Master User CodeWhen assigned to a user, this property allows the user to act as a master user. The Master User Codehas full access to programming all the user options. For a full list of user programmable options, refer tothe X64 User Manual.