IDS X64 Installer Manual

Also see for X64: Training manual User manual User manual Installer manual Manual

Contents

IDS X64 Installer Manual Manual pdf 54 page image

Section: 9IDS X64 Installer Manual 700-398-02D Issued August 201054The valid data range is: 00m00s – 59m59s.Partition no. is: 1-8.Refer to section 8.3.2 Using Sub-locations to see how to scroll from one sub-location to another using the[*] key.LOCATION 231 Primary Entry Delay Period (default = 0030)The primary entry delay begins after the violation of a Primary Entry/Exit zone. During this delay, it ispermissible to violate Follower zones without causing an alarm condition if an Entry/Exit zone wasviolated first.If a Follower zone is violated without a prior Entry/Exit zone violation, it will be treated as an Instant zone.If an Instant zone is violated during this period, an alarm condition will immediately be registered.Enter a 4-digit entry delay period for each of the 8 partitions and program as a 32-digit string,followed by the [*] key.[INSTALLER CODE] [*] [2] [3] [1] [*] [PARTITION NO.] [*] [MMSS] [*]The valid data range is: 00m00s – 59m59s.Partition no. is: 1-8.Refer to section 8.3.2 Using Sub-locations to see how to scroll from one sub-location to another using the[*] key.LOCATION 232 Secondary Entry Delay Period (default = 0030)The secondary entry delay begins after the violation of a Secondary Entry/Exit zone. During this delay, it ispermissible to violate Follower zones without causing an alarm condition if an Entry/Exit zone wasviolated first.Enter a 4-digit entry delay period for each of the 8 partitions and program as a 32-digit string,followed by the [*] key.[INSTALLER CODE] [*] [2] [3] [2] [*] [PARTITION NO.] [*] [MMSS] [*]The valid data range is: 00m00s – 59m59s.Partition no. is: 1-8.Refer to section 8.3.2 Using Sub-locations to see how to scroll from one sub-location to another using the[*] key.9.13 Options to Configure KeypadsLOCATION 240 Keypad Partition (default = Partition 1)Program this location to allocate each keypad to a partition. Enter the partition number to which eachkeypad, with an ID 1-8, must be allocated. To view the ID of a keypad refer to location 243.Enter 1 digit for each of the 8 keypads and program as an 8-digit string, followed by the [*]key.