VIIQUICK REFERENCE GUIDE■ Programmed scan operation25 pairs, 50 channels of memories are used for programmedscan operation, that specify a scanning range. The pro-grammed scan scans between “xxA” and “xxB” (xx=00 to 24)frequencies. Therefore, before operating the programmedscan, different frequencies must be programmed into “A” and“B” channels.DD Programming scan edgesA start frequency must be programmed into a “xxA,” and endfrequency must be programmed into a “xxB” memory channel.1. Setting frequencyIn VFO mode, set the desired receive frequency mode.• When “μμ ” indicator is displayed, push [VFO MHz] to select theVFO mode.2. Selecting a scan edgechannel “A”Push [MR S.MW] for 1 sec., thenrotate [R-DIAL] to select one ofthe desired scan edge channel“A.”• “μμ ” indicator blinks.3. Writing a memory channelPush [MR S.MW] for 1 sec. until3 beeps sound.• Scan edge channel “B” is automat-ically selected when continuing topush [MR S.MW] after program-ming.• After programming is completed,return to VFO indication.4. Selecting a scan edgechannel “B”Push [MR S.MW] for 1 sec., then ro-tate [R-DIAL] to select one of thedesired scan edge channel “B.”• “μμ ” indicator blinks.• When the scan edge channel “B” is al-ready selected at step 3. (continuing topush [MR S.MW] after programming),skip this step.5. Writing a memory channelPush [MR S.MW] for 1 sec. until 3 beeps sound.• The next scan edge channel “A” is automatically selected when con-tinuing to push [MR S.MW] after programming.• After programming is completed, return to VFO indication.FM-BNAME:-BNAME:-BANKBANK-:----:----03B03Bμ.146.0101 2 34 5 6 07 8 9BANDDUALWATCH MAIN/SUB POWERVFOMHz MODESCAN MRS.MWSCOPELOCKRECAFCMRS.MWFrontTop1 2 34 5 6 07 8 9BANDDUALWATCH MAIN/SUB POWERVFOMHz MODESCAN MRS.MWSCOPELOCKRECAFCMRS.MWFrontFM-BNAME:-BNAME:-BANKBANK-:----:----03A03Aμ.146.0101 2 34 5 6 07 8 9BANDDUALWATCH MAIN/SUB POWERVFOMHz MODESCAN MRS.MWSCOPELOCKRECAFCMRS.MWFrontTop