Icom IC-R20 Instruction Manual

Also see for IC-R20: Price list Instruction manual Service manual Service manual

Contents

Icom IC-R20 Instruction Manual Manual pdf 57 page image

448PRIORITY WATCHDD VFO scan watchq Select memory mode.• Select a memory bank, if desired.wPush [MODE SCAN] for 1 sec. to start memory/bank scan,if desired.While scanning memory/bank channels:Starts memory/bank scan first. Memory/bank scan can-not be started after VFO scan is started.e Push [8 SET] for 1 sec. to enter set mode.r Rotate [R-DIAL] to select “PRIO,” then push [8 SET].t Rotate to turn the priority watch ON, then push [8 SET].• Select “BELL” if the priority beep function is necessary.y Push [DUALWATCH] to exit set mode and start the watch.• “PRIO” indicator appears.uPush and hold [MODE SCAN] to enter scan type selectioncondition.iRotate [R-DIAL] to select the desired scan type from“ALL,” “BAND” and “PROG-xx (xx= 0–24) .”o Release [MODE SCAN] to start the VFO scan watch.• The receiver checks the memory channel(s) every 5 sec.• The watch resumes according to the selected scan resume con-dition. (p. 41)!0 Push [DUALWATCH] to cancel the watch and scan.√ μMODE ANLAFCPRIOTSQLFM1888 888PSKIP-DUP001 √ μMODE ANLAFCPRIOTSQLFM145 870PSKIP-DUP001√ μMODE ANLAFCPRIOTSQLFM1888 888PSKIP-DUP001 √ μMODE ANLAFCPRIOTSQLFM145 870PSKIP-DUP001• During priority watchMonitors VFO frequencyfor 5 sec.Pauses on a memory(bank) channel when asignal is received.• During priority watch with priority beepEmits beep and blinks “S” indicator when a signal is re-ceived on a memory (bank) channel.8