377 SCAN OPERATION■ Memory/bank/all bank scanq Select memory mode with [MR S.MW].• Select the desired bank with [BAND] for bank scan.w Set the squelch level.eWhile pushing and holding [MODE SCAN], rotate [R-DIAL]to select the desired scanning type.• “ALL” for all bank scan; “BANK-LINK” for bank link scan or“BANK-x” for bank scan. (x= A to Z; programmed bank groupsonly displayed.)r Release [MODE SCAN] to start the selected scan.• Scan pauses when a signal is received.• Rotate [R-DIAL] to change the scanning direction, or resumesmanually.t To stop the scan, push [DUALWATCH].IMPORTANT!: To perform memory or bank scan, 2 ormore memory/bank channels MUST be programmed, oth-erwise the scan will not start.The bank-link setting can be changed in expanded setmode. See page 58 for details.√ μMODE ANLAFCTSQLFM888 800PSKIP-DUP012 √ μMODE ANLAFCTSQLFM888 800PSKIP-DUPP01• During memory/all/bank scan • During bank scanSCAN:ALL√ μMODE ANLAFCTSQLFM146 010PSKIP-DUP088SCAN:BANK-LINK√ μ PSKIP121SCAN:BANK-A√ μ PSKIPA01• Full memory scan selection• Band link scan selection• Bank scan selectionSelectable between “A” to “Z”if programmed[R-DIAL]MODESCANMRS.MW
