Icom IC-R20 Instruction Manual

Also see for IC-R20: Price list Instruction manual Service manual Service manual

Contents

Icom IC-R20 Instruction Manual Manual pdf 56 page image

438 PRIORITY WATCH■ Priority watch operationDD Memory channel watch and memory scan watchq Select VFO mode; then, set an operating frequency.w Set the watching channel(s).For memory channel watch:Select the desired memory channel.For memory scan watch:Select memory mode, or the desired bank group; then,push [MODE SCAN] for 1 sec. to start memory/bank scan.e Push [8 SET] for 1 sec. to enter set mode.rRotate [R-DIAL] to select “PRIORITY WATCH,” then push[8 SET].tRotate [R-DIAL] to turn the priority watch ON, then push[8 SET].• Select “BELL” if the priority beep function is necessary.y Push [DUALWATCH] to exit set mode and start the watch.• “PRIO” indicator appears.• The receiver checks the memory/bank channel(s) every 5 sec.• The watch resumes according to the selected scan resume con-dition. (p. 41)u Push [DUALWATCH] to cancel the watch.√ μMODE ANLAFCPRIOTSQLFM439 975PSKIP-DUP001 √ μMODE ANLAFCPRIOTSQLFM145 870PSKIP-DUP001√ μMODE ANLAFCPRIOTSQLFM439 975PSKIP-DUP001 √ μMODE ANLAFCPRIOTSQLFM145 870PSKIP-DUP001• During priority watchMonitors VFO frequencyfor 5 sec.Pauses on a memory(bank) channel when asignal is received.• During priority watch with priority beepEmits beep and blinks “S” indicator when a signal is re-ceived on a memory (bank) channel.-NOISE-BLANKER-POWER-SAVE-BACKLIGHT-BEEP-LEVEL-KEY-TOUCH-BEEP>PRIORITY-WATCH----------------PRIORITY-WATCH-BELL>ON-OFF----------------***-SET-MODE-***[R-DIAL]SET8MRS.MWMODESCAN