326MEMORY CHANNELS■ Memory clearingContents of programmed memories can be cleared (blanked),if desired.qPush [MR S.MW] for 1 sec. to select the select memorywrite condition.• 1 short and 1 long beeps sound.• “μμ ” indicator blinks.• Do not hold [MR S.MW] for more than 2 sec. otherwise thememory contents will be copied to VFO.wRotate [R-DIAL] to select the desired memory channel tobe cleared.eWhile pushing [8 SET], rotate [R-DIAL] to select “CLEAR.”• “CLEAR” item can also be selected by pushing [8 SET] severaltimes.r Push [MR S.MW] for 1 sec. to clear the contents.• 3 beeps sound.• The cleared channel changes to blank channel• Return to the select memory write condition.— “μμ ” indicatorblinks. Push [DUALWATCH] to exit the select memory write con-dition, then push [VFO MHz] to return to VFO mode.NOTE: Be careful!— the contents of cleared memoriesCANNOT be recalled even in bank channel operation.FM>CLEAR-SKIP-:OFF-MNAME:-BNAME:-BANK-:----028μ.144.010FM>CLEAR-SKIP-:OFF-MNAME:-BNAME:-BANK-:----028μ.144.010Push for 1 sec.MRS.MWFM>CLEAR-SKIP-:OFF-MNAME:-BNAME:-BANK-:----028μ.144.010>CLEAR-SKIP-:OFF-MNAME:-BNAME:-BANK-:----is pushedseveral times.After[R-DIAL]SET8SET8MRS.MWSET TS:5.0kHz√MODE ANLAFCTSQLFM146 010PSKIP-DUP6
