Icom IC-R20 Instruction Manual

Also see for IC-R20: Price list Instruction manual Service manual Service manual

Contents

Icom IC-R20 Instruction Manual Manual pdf 39 page image

266MEMORY CHANNELS■ General descriptionThe receiver has 1050 memory channels including 50 scanedge memory channels (25 pairs) for storage of often-usedfrequencies. And a total of 26 memory banks, A to Z are avail-able for usage by group, etc. Up to 100 channels can be as-signed into a bank.DD Memory channel contentsThe following information can be programmed into memorychannels:• Operating frequency (p. 14)• Receive mode (p. 16)• Duplex direction (+DUP or –DUP) with an offset fre-quency (p. 20)• Tone squelch or DTCS squelch ON/OFF (p. 45)• Tone squelch frequency or DTCS code with polarity(p. 46)• Scan skip information* (p. 39)■ Memory channel programmingq Push [VFO MHz] to select VFO mode.w Set the desired frequency:➥ Select the desired band with [BAND].➥ Set the desired frequency with [R-DIAL].➥ Or set the desired frequency with [KEYPAD].➥ Set other data (e.g. offset frequency, duplex direction, tonesquelch, etc.), if desired.ePush [MR S.MW] for 1 sec. to select the select memorywrite condition.• 1 short and 1 long beep sound.• “μμ ” indicator blinks.r Rotate [R-DIAL] to select the desired channel.• Scan edge channel, 00A/B to 24A/B can also be selected.t Push [MR S.MW] for 1 sec.• 3 beeps sound• Memory channel number automatically increases when contin-uing to push [MR S.MW] after programming.[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel).√ μMODE ANLAFCTSQLTSQLFMFM145 870PSKIP-DUP-DUP001 √ μMODE ANLAFCTSQLTSQLFM145 870PSKIP-DUP-DUP020 √ μMODE ANLAFCTSQLTSQLFM145 870PSKIP-DUP-DUP020>CLEARCLEAR-SKIPSKIP-:OFF:OFF-MNAME:MNAME:-BNAME:-BNAME:-BANKBANK-:----:----001001μ.146 .010FM>CLEARCLEAR-SKIPSKIP-:OFF:OFF-MNAME:MNAME:-BNAME:-BNAME:-BANKBANK-:----:----020020μ.--------------------------------Push for 1 sec. RotateMRS.MW Push for 1 sec.MRS.MW56