4-52 Configuring Your ServerDefault settings and their explanationItem Default Description ChangeBattery Backup PresentNoneDisplays Properties.• When battery is installed: Present• When battery is not installed: None–Set Factory Defaults [No]YesRestores factory defaults. PermittedCluster Mode Disabled – ProhibitedRebuild Rate 30 Recommended value: 30 PermittedPatrol Read Rate 30 Recommended value: 30 PermittedBGI Rate 30 Recommended value: 30 PermittedCC Rate 30 Recommended value: 30 PermittedReconstruction Rate 30 Recommended value: 30 PermittedAdapter BIOS [Enabled]Disabled– ProhibitedCoercion Mode [None]128MB-way1GB-way– ProhibitedPDF Interval 300 – ProhibitedAlarm Control [Disabled]EnabledSilenceDisabled: Does not issue an alarm. Prohibited *2Cache Flush Interval 4 – ProhibitedSpinup Drive Count 2 – Prohibited *1Spinup Delay 6 – Prohibited *1StopOnError [Disabled]Enabled– Prohibited*1 After performing Set Factory Defaults, change values of "Spinup Drive Count" and "SpinupDelay" as shown in the table above, if they are not.*2 Error notification by beep sound is not issued even if Alarm Control is set to Enabled.
