4-128 Configuring Your ServerThe following figure illustrates the jumper switch location. Pins for protecting/clearing the passwordsShort-circuit these two pins to clear the passwords.Open these two pins to protect the passwords (factory-set). Pins for protecting/clearing the CMOS dataShort-circuit these two pins to clear the CMOS data.Open these two pins to protect the CMOS data (factory-set).7. Reassemble the server and press the POWER switch.8. When the POST screen appears, power off the server and unplug the power cord.9. Restore the jumper switch setting.NOTE: Place the clip over the jumper pins 11 and 12 after use to keepthe pin. Placing the clip over any other pins may cause malfunction ofthe server.10. Reassemble the server and press the POWER switch.11. Run BIOS setup utility and restore the parameter settings recorded in Step 1.If you have cleared the password, set it again as needed.12. Save and exit the utility.Pins 11 and 12Pins for protecting/clearingthe passwords.Pins for protecting/clearingthe CMOS data.Jumper clip
