Upgrading Your Server 9-25PCI Access CoverTo install or remove a non-hot-swap PCI board, remove the PCI access cover inside the server. Youneed not to remove the PCI access cover when you work with hot-swap PCI slot.Removal1. See the section "Preparing for Installation and Removal" described earlier to prepare.2. Pull out the server from the rack.3. Remove the rear access cover.4. Loosen the screw securing the PCI access cover.5. Hold the end of the cover (the end where the screw is loosened), and take out the coverslowly and gently.InstallationTake the following steps to install the PCI access cover.1. Orient the PCI access cover with the screw toward the front of the server.2. Insert the tab on the rear side of the PCI access cover into the chassis slot.3. Slowly and gently put the cover on the chassis, and secure it with a screw.
