Upgrading Your Server 9-59RemovalRemove the DIMM in the following procedure.IMPORTANT: The DIMM is extremely sensitive to static electricity.Make sure to touch the metal frame of the server to discharge staticelectricity from your body before handling the DIMM. Do not touch theDIMM terminals or on-board parts by a bare hand or place the DIMMdirectly on the desk. For static notes, see the section "Anti-staticMeasures" described earlier.NOTE: To remove the failed DIMM, check the error messageappearing in POST or NEC ESMPRO to identify the DIMM socket(group) in which the failed DIMM is installed.1. See the section "Preparing for Installation and Removal" described earlier to prepare.2. Unlock the front bezel with the security key, and remove the front bezel.3. Remove the memory slot cover, and then remove the memory board on which the DIMMsto be removed are installed.NOTE: The error lamp corresponding to the failing DIMM goes on.4. Open the levers at both sides of the socket from which you remove the DIMM.(1).The DIMM is unlocked and ready for removal.(2)5. Install the memory board.6. Install the memory slot cover and front bezel.7. Power on the server and verify that POST displays no error messages.If POST displays an error message, take a note on the message and see the POST errormessages listed in Chapter 8.8. Start the SETUP and select [Advanced] → [Memory Configuration] → [Memory Retest]→ [Enabled] to clear the error information of the removed DIMM. Then, Then, select[Server] → [Clear FRU LED] → [Yes] to turn off the LED indicating DIMM error. (SeeChapter 4 for details.)9. Select "Yes" for [Reset Configuration Data] on the Advanced menu.This setting is required to change the hardware configuration data. See Chapter 4 fordetails.
