Installing the Operating System with Express Setup 5-117. Notes and restrictions are displayed.Read the messages carefully and click [Confirm].NOTE: If some operating system has been installed on the hard diskalready, the message which asks if you continue the installationappears.If you wish to continue the installation, click [Continue].8. If you select "Yes" at step 5, place a floppy disk into the floppy disk drive mounted on theserver.If not, go on the next step.NOTE: If you set the floppy disk at this step, do not remove thefloppy disk from the server until the message as removing the floppydisk appears.[Using the existing Configuration Disk]The parameters files in the floppy disk is listed in dialogue-box.1) Select a parameters file to use in the Express Setup, and then click [Use].After the parameters file is specified, the message "Do you want to review or modifythe Setup File parameters?" appears.2) If you want to modify or confirm the parameters file, click [Review]. If not, click[Skip].Click [Review] → Go on the next step.Click [Skip] → Go on the step 10.[Using a blank disk]1) Click the box under [Setup File Name: (A)] or press A.The dialog box appears.2) Input the file name and click [Use].9. Confirm or modify the parameters of disk array configuration.[Configure RAID] screen appears. Confirm the specification, modify if necessary, andthen click [OK].NOTE: Choose RAID0 when you install it in one hard disk.When the dialogue-box is closed, the Express setup automatically performs the RAIDconfiguration, creating Maintenance partition and installing several utilities.10. Select the installing Operating system.Select "Windows" from the menu.
