Answering calls 25P0908510 Issue 02 Enterprise Edge Feature Programming Telephone GuideOn a M7100 telephone:1. Press ƒ£‹. The first party is on hold.2. Press ˙, if necessary, to switch parties.You can re-establish the conference.3. Press ƒ‹.4. Take the held call off hold. This is not necessary for the M7100 telephone.Removing yourself from a conferenceƒ‡‚You can remove yourself from a conference, and connect the other two callersthrough your Enterprise Edge system.Enter the Transfer feature code ƒ‡‚.When you remove yourself from a conference using the Transfer feature, and bothcallers are from outside your system, one of the callers must have called you on adisconnect supervised line, or the call is be disconnected.DisplaysYou are trying to add a fourth party to your conferencecall, or to join two conferences together. Release onecall from the conference before adding another, orkeep the two conferences separate.You have put a conference call on hold.You have tried to make a conference call, but yoursystem is already handling its maximum number ofconference calls.You are on a conference with the two lines ortelephones shown. You can drop out of the conferenceand leave the other two parties connected(Unsupervised Conference) by pressing TRANSFER orentering the Transfer feature code.You have activated the Conference feature with onecall active and another on hold. Press the line of thecall on hold to bring that person into the conference.For other displays, see Common feature displays on page 125.3 parties onlyConf. on holdConference busyLine001 221TRANSFERPress held line
