34 Making callsEnterprise Edge Feature Programming Telephone Guide P0908510 Issue 02Changing how you dial your callsƒ•°¤1. Press ƒ•°¤.2. Press £ or NEXT until the dialing mode you want appears.3. Press ˙ or OK to select the displayed dialing mode.The dialing modes feature code cannot be programmed onto a memory button.Using Standard dialStandard dial allows you to make a call by selecting a line and dialing the number.If you have a prime line, it is selected automatically when you lift the receiver orpress ©.You cannot use Standard dial on a M7100 telephone unless you pick up the receiverfirst. If you have a M7100 telephone, use the Automatic dial or Pre-dial feature foron-hook dialing.Using Automatic dialAutomatic dial allows you to dial a number without selecting a line. Your prime lineis selected as soon as you start dialing a number.Automatic dial does not work if your telephone has no prime line or if your primeline is in use.Telephones connected to an Enterprise Edge Analog Terminal Adaptor (ATA2) oran Enterprise Edge Analog Station Module (ASM) cannot use Automatic dial.Using Pre-dialPre-dial allows you to enter a telephone number, check it, then change it beforeactually making the call. The call is not dialed until you select a line or line pool, orpick up the receiver. You can pre-dial both external and internal numbers. Youmust, however, select the correct type of line (external or internal) for the type ofnumber you have entered.TipIf your telephone starts ringing while you are pre-dialing a number, you canstop the ringing by turning on Do Not Disturb (ƒ°fi). This doesnot affect numbers you are entering.You cannot pre-dial a telephone number if all the lines on your telephone arebusy.