Making calls 33P0908510 Issue 02 Enterprise Edge Feature Programming Telephone GuideThe Enterprise Edge system can have 15 line pools plus 6 PRI pools, and atelephone can be programmed to access any number of them.A line pool access code is a number you dial to get a line pool. The access code canbe up to four digits long. You can have several different line pools for your system,each one giving you access to a different set of external lines. It is one way ofsharing lines across telephones in a system.Your installer programs the line pool access codes and gives each telephone accessto a line pool.Everyone in the office should have a list of the line pool access codes for the linepools their telephones can use.Using a line pool to make a callƒfl›1. Press ƒfl›.2. Enter a line pool access code.If you have a free internal line, you can make a call using a line pool withoutentering the feature code first.1. Select an internal line (intercom).2. Dial the line pool access code.Programming a memory button with a line pool feature codeWhen you program a button with the line pool feature code, you must enter a linepool access code after the feature code. The programmed line pool button accessesa specific line pool, not the line pool feature. See Programming feature buttons onpage 74 for more information.If you program a button with an indicator to access a line pool, when all the lines ina line pool are busy, the indicator for the line pool button turns on. The indicatorturns off when a line becomes available.TipIf no lines are available in the line pool, you can use Ring Again at the busytone. You are notified when a line in the line pool becomes available.See Using Ring Again on page 36.
