Communicating in the office / 121P0992640 03 Modular ICS 6.0 System Coordinator Guidesend messages to analog telephones by pressing ²Ú.Depending on the programming setup, the analog telephoneprovides either a Stuttered Dial Tone or a Message WaitingLamp to inform the user of messages pending.If your reply to a message is forwarded or is answered atanother telephone using the Call Pickup feature, the messageremains on your telephone until you cancel it or successfullycontact the telephone that sent the message.For analog telephones connected to an ASM, the messagewaiting indicator remains on until the user invokes˚£ßÞ. If the analog telephone has the MessageReply Enhancement feature set to Yes, the message waitingindicator is turned off automatically after the reply call isanswered no matter from where the call is answered.For more information on the Message Reply Enhancementfeature, see the Norstar Modular ICS 6.0 Installer Guide.1. Press ²Ú.2. On a telephone with a two-line display, press ADD.Note: This step is not necessary on a telephone with a one-line display.3. Enter the internal number of the person to whom you wantto send the message. The person’s display readsMessage for you.4. On analog telephones connected to an Analog StationModule (ASM), the message waiting indicator is activated.Canceling a message you have sent1. Press ²£Ú. The display reads Cancel for:.2. Enter the internal number of the person to whom you sentthe message.
