170 / Programming Hunt GroupsModular ICS 6.0 System Coordinator Guide P0992640 031. Place the appropriate programming overlay on the set youare using to do programming.2. Press ²¥¥ÛßßÜÝÝ (CONFIG). Thedisplay shows Password:.3. Press ÛÜßÝß (ADMIN). The display showsTerminals&Sets.4. Press ‘ until the display shows Systemprgrming.5. Press ≠. The display shows Hunt groups.6. Press ≠. The display shows Show group.7. Enter the Hunt Group number you want to program (1-30).8. Press ≠. The display shows Member DNs:.9. Press ‘ until the display shows If busy:.10. Press CHANGE to set the mode: BusyTone, Overflow,Queue.11. Press ¨ to exit or ‘ to continue programming.Programming the queue time-outThis setting allows you to program the number of seconds acall remains in the Hunt Group queue before it is routed to theoverflow position.1. Place the appropriate programming overlay on the set youare using to do programming.2. Press ²¥¥ÛßßÜÝÝ (CONFIG). Thedisplay shows Password:.3. Press ÛÜßÝß (ADMIN). The display showsTerminals&Sets.