168 / Programming Hunt GroupsModular ICS 6.0 System Coordinator Guide P0992640 031. Place the appropriate programming overlay on the set youare using to do programming.2. Press ²¥¥ÛßßÜÝÝ (CONFIG). Thedisplay shows Password:.3. Press ÛÜßÝß (ADMIN). The display showsTerminals&Sets.4. Press ‘ until the display shows Systemprgrming.5. Press ≠. The display shows Hunt groups.6. Press ≠. The display shows Show group.7. Enter the Hunt Group number you want to program (1-30).8. Press ≠. The display shows Member DNs:.9. Press ‘ until the display shows Mode.10. Press CHANGE to set the mode: Sequential, Rotary,Broadcast.11. Press ¨ to exit or ‘ to continue programming.Setting the hunt delayThis setting allows you to program the number of rings thesystem permits at a Hunt Group set before moving on to thenext set in the Hunt Group.1. Place the appropriate programming overlay on the set youare using to do programming.2. Press ²¥¥ÛßßÜÝÝ (CONFIG). Thedisplay shows Password:.3. Press ÛÜßÝß (ADMIN). The display showsTerminals&Sets.
