Using System features / 223P0992640 03 Modular ICS 6.0 System Coordinator GuideTurning the auxiliary ringer for a telephone on or offYou need the programming template found at the front of thisguide. See Getting started with Norstar on page 13 for moreinformation.1. Press ²¥¥ÛßßÜÝÝ.2. Press ÛÜßÝß (the default System Coordinatorpassword).3. Press ≠ at Terminals&Sets.4. Enter the internal number of the telephone you want toprogram and press ≠. The display readsCapabilities.5. Press ≠.6. Press ‘ until the display reads Aux. ringer.7. Use CHANGE to select Y (Yes) or N (No).Your installer or customer service representative can programthe auxiliary ringer to start ringing for incoming lines as partof Ringing Service.Using Host System dialing signalsYou can access host systems, such as private branchexchanges (PBX) from Norstar by using host system signalingfeatures (known as end-to-end signaling). These featureseither send a special signal to the host system or allow you toprogram delays required by host systems in external autodialor speed dial sequences.Link²àÚ