EXPLORER BALANCES EN-92.2.5 Installing the Weighing Pan & Wind Shield – Non-Draft Shield ModelsNote: Assembly instructions also apply to models with the suffix M or N.1. Place the four Support Caps onto the Balance as shown.2. Place the Weighing Pan on the Support Caps3. Place the Wind Shield onto the Balance as shown.Note: The balance can be operated without the Wind Shield. However, depending on ambient conditions thedisplayed results may be slightly less stable.2.3 Selecting the LocationAvoid excessive vibrations, heat sources, air current, or rapid temperature changes. Allow sufficient space.Note: Interface cables connect to the terminal. The terminal can be detached and mounted on a wall orpositioned on a table separate from the balance.2.4 Leveling the EquipmentThe Explorer has an illuminated level indicator as a reminder that the balance shouldbe leveled for accurate weighing. There is a level bubble in a small round window onthe front of the Base. To level the balance, adjust the Leveling Thumbwheels at eachcorner until the bubble is centered in the circle.Be sure the equipment is level each time its location is changed.Note: The feet cannot rotate. The Thumbwheels must be used for leveling.See the Level Assist screen in the Information Menu.To see the Level Assist menu, touchMore on the bottom-right corner of themain screen. Then touch Level Assist.The Level Assist screen shows whichdirection to turn the thumbwheels tocenter the level bubble.
