EN-10 EXPLORER BALANCES2.5 Connecting Power2.5.1 AC AdapterConnect the power cord of the AC Adapter (supplied) to the power receptacle on the rear of the Base.Then connect the AC adapter plug to a suitable electrical outlet.Caution: For use with CSA certified (or equivalent approved) power source,which must have a limited current output.Note: Allow equipment to warm up for 60 minutes for optimal weighing performance.Standby: When unit is plugged in, it starts in Standby mode. Press the Standby icon to start.2.6 Connecting the InterfaceUse the built-in RS-232 (10101) Port to connect either to acomputer or a printer with a standard (straight-through) serialcable. Or connect using the scale’s USB port.Note: For configuration and interface commands, see theCommunication Menu Settings section.For Connecting, Configuring and Testing the Printer/ComputerInterface, and for sample Print Output Formats, see the Printingsection.Interface connections on back of Terminal.Thread printer cable along cable coils on bottom of balance. Or pass cable through groove near release button.2.7 Adjusting the View Angle of the TerminalTo adjust the Terminal display’s viewing angle, press in the Terminal Adjust buttons on both sides of the Terminal.