EXPLORER BALANCES EN-112.8 Remote Terminal OperationThe Terminal communicates with the weighing base via the Terminal cable. This cable must be plugged into theTerminal for the Explorer to display properly. If desired, the Explorer balance may be operated either with theTerminal attached (as-shipped), or remotely (up to 1 meter away).2.8.1 Separating the Terminal from the Weighing Base1. To detach, press both the Release buttons inward (both at the same time) and gently pull the Terminaltowards you (outward) until the Terminal is detached. These Release buttons disengage the two hooksholding the Terminal to the Base. A cable is attached to the Terminal. Take care to not damage ordisconnect this cable.2. To reattach the Terminal, press in the two Release buttons and slide the Terminal into the Base until theTerminal hooks click and engage to hold the Terminal in place.Release Button Base and Terminal Terminal CableNote: If a longer operation distance is required, a Terminal Extension cable is available as an accessory.2.8.2 Terminal MountingIf desired, the Terminal may be mounted to a wall or table using fasteners (not supplied) that are appropriate for thetype of mounting surface The Terminal bracket will accommodate 4mm (#8) screws. Locate the mounting holes asshown in Figure 2-1.Figure 2-1. Terminal Mounting Dimensions.2.9 Initial CalibrationWhen the Balance is first installed, and when it is moved to another location, it must be calibrated to ensureaccurate weighing results. The Explorer Balances have built in AutoCal which can calibrate the balanceautomatically and does not require calibration masses. If preferred, the balance can be manually calibrated withexternal masses. Have the appropriate calibration masses available before beginning calibration. Refer to theCalibration Section for masses and calibration procedure.56.5 mm2.2 in112 mm / 4.4 in48.5 mm1.9 in