CS240/CS231 13-43Utility mode 136 Touch the button for the paper type to be set.7 Press the [Start] key.– Only paper loaded into the bypass tray can be used.A test pattern is printed.8 Check that the distance from the starting print position of thetest pattern to the edge of the paper (c) is 4.2 mm.– If the distance is less than 4.2 mm, touch [+] to increase theadjustment (between 0.2 mm and 3.0 mm).– If the distance is more than 4.2 mm, touch [-] to reduce theadjustment (between -0.2 mm and -3.0 mm).– Each time [+] or [-] is touched, the value is increased ordecreased by one increment.9 Press the [Start] key.The adjusted test pattern is printed.10 Check the distance from the starting print position of the test pattern to the edge of the paper.– Check that the distance has been adjusted to 4.2 mm.– If more adjustment is necessary, repeat steps 8 and 9.– To adjust the print position for a different paper type, return to step 6.11 Touch [OK].The print position is adjusted.Centering (Duplex 2nd side)The starting print position at the left edge of the paper for the second side during automatic double-sidedcopying for each paper tray can be adjusted.0 The starting print position is adjusted during manufacturing of the machine. Normally, the starting printposition will not need to be adjusted.0 Only A4 v paper can be used to adjust the bypass tray.1 Display the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to "Displaying the administratorsettings screen" on page 13-35.2 Touch [1 System Settings].The System Settings screen appears.3 Touch [7 Expert Adjustment].The Expert Adjustment screen appears.cc: 3.0 mm ± 0.5 mm
