13 Utility mode13-46 CS240/CS231Center staple position adjustmentThe stapling position when printing with the "Center Staple & Fold" setting can be adjusted for each papersize.2 NoteCS240: [Center Staple Position Adjustment] does not appear if optional Finisher FS-608 is not installed.CS231: [Center Staple Position] appears only if optional finisher FS-608 is installed or if finisher FS-519is installed with the saddle stitcher attached.If the angle of the staple must be adjusted, contact your technical representative.The adjustment range differs depending on the finisher that is installed.!DetailFor details on the "Center Staple & Fold" setting, refer to "Binding copies at the center ("Center Staple& Fold" setting)" on page 4-75.For the procedure on adjusting the center folding position, refer to "Half-fold position" on page 13-48.0 Adjust the center folding position before adjusting the center stapling position.0 Before making any adjustments, use the "Center Staple & Fold" setting to print a single sample copy.Perform the adjustment while checking the sample that was created.1 Display the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to "Displaying the administratorsettings screen" on page 13-35.2 Touch [1 System Settings].The System Settings screen appears.3 Touch [7 Expert Adjustment].The Expert Adjustment screen appears.4 Touch [3 Finisher Adjustment].The Finisher Adjustment screen appears.
