Configuring your machine for a wireless network353LCD messages when using the SES/WPS/AOSS™ control panel menu 3(Windows® )You have completed the wireless network setup. If you would like to continue installing driversand software necessary for operating your device, please choose Install Multi-Function Suitefrom the CD-ROM menu.(Macintosh)You have completed the wireless network setup. If you would like to continue installing driversand software necessary for operating your device, please choose Start Here OSX from theCD-ROM menu.Using the Océ installer application on the CD-ROM to configure your machinefor a wireless network 3For installation, see Wireless configuration for Windows ® using the Océ installer application in Chapter 4 andWireless configuration for Macintosh using the Océ installer application in Chapter 5.LCD shows Connection status ActionSetting WLANSearching or accessing the accesspoint, and downloading settings from theaccess point.—Connecting SESConnecting WPSConnecting AOSSConnecting the access point. —Connected Connection succeeded. —Connection Error Session overlap has been detected.Check that only one router or access point hasthe automatic wireless setup(SecureEasySetup™, AOSS™, etc.) modeenabled and try starting from step c again.No Access Point The access point detection failed. Move the machine closer to your accesspoint/router and try starting from step c again.Connection Fail Connection failed.1 Try starting from step c again.2 If the same message continues, reset themachine back to the factory settings and tryagain.
