Wireless configuration for Macintosh using the Océ installer application755i Press Menu, 7, 2, 3 for SES/WPS/AOSS.This feature will automatically detect which mode (SecureEasySetup™, AOSS™, etc.) your access pointuses to configure your machine.j The machine searches for an access point that supports the automatic wireless setup(SecureEasySetup™, AOSS™, etc.) for 2 minutes.72.WLAN3.SES/WPS/AOSSSetting WLANk Put your access point in the automatic wireless setup (SecureEasySetup™, AOSS™, etc.) mode,depending on what is supported by your access point. Please refer to the instruction manual that camewith your access point. You will see Connecting AOSS, Connecting SES or Connecting WPS onthe LCD while the machine searches your access point.l If the LCD shows Connected, the machine has successfully connected to your access point/router. Youcan now use your machine in a wireless network.If the LCD shows Connection Error, a session overlap has been detected. The machine hasdetected more than one access point/router on your network with the automatic wireless setup(SecureEasySetup™, AOSS™, etc.) mode enabled. Make sure that only one access point/router hasthe automatic wireless setup (SecureEasySetup™, AOSS™, etc.) mode enabled and try starting fromstep i again.If the LCD shows No Access Point, the machine has not detected your access point/router on yournetwork with the automatic wireless setup (SecureEasySetup™, AOSS™, etc.) mode enabled. Move themachine closer to your access point/router and try starting from step i again.If the LCD shows Connection Fail, the machine has not successfully connected to your accesspoint/router. Try starting from step i again. If the same message is indicated again, reset the machineback to the default factory settings and try again. (For resetting, see Restoring the network settings tofactory default on page 119.)
