Basic copy operations33-6 VL6522c/VL5522c/VL4522c3.2Placing the original on the original glass0 When placing the original on the original glass, be sure to lift open the ADF at least 15°. If the originalis placed on the original glass without the ADF being lifted at least 15°, the correct document size maynot be detected.0 Do not place an original weighing more than 2kg on the original glass. Furthermore, do not use a strongforce to press down on a book or any other form of original that must be spread on the original glass.Otherwise, the machine may be damaged or a failure may occur.0 For thick books or large objects, perform scanning without closing the ADF. When a document is beingscanned with the ADF open, do not look directly at the original glass surface where light may be emittedthrough. Note, however, that the light coming through the original glass is not a laser beam, and will notexpose the user to the related hazards.0 When Non-Image Area Erase is selected, you do not have to close the ADF to copy the original. Placethe original anywhere on the original glass. The area surrounding the original text will be excluded fromthe copy. For details, refer to page 5-43.1 Lift open the ADF.2 Place the original face down on the original glass.% Load the original by placing it so that its top side faces theback or the left side of the machine.3 Align the original with the mark in the back-left corner of theoriginal scales.% For transparent or translucent originals, place a blank sheet ofpaper of the same size as the original over the original.% For bound originals spread over two facing pages, such as abook or a magazine, position the top of the original toward the back of this machine and align theoriginal with the mark in the back-left corner of the original scales.% When Non-Image Area Erase is selected, the original can be placed anywhere on the original glass.4 Close the ADF.