Preparation17The remote controlInsert the battery1 Push the catch in the direction shown byarrow to remove the holder. Insert the battery with the “+” marked sidefacing up. Return the holder to its original position.When the battery (CR2025) has run out, replaceit with a new one. (The battery lasts about oneyear, depending on the frequency of use.)If the remote control unit fails to work even whenit is operated near the camera-recorder’s remotecontrol sensor, the battery has run out.Keep the battery out of the reach of children.••Remote control setupWhen using two camera-recorders simultaneously,set this camera-recorder and the remote controlto either “operation mode 1” or “operation mode 2”so the remote control does not operate the wrongcamera-recorder by mistake.SettingWireless remote controlPress the MCR operation buttons STOP ( g )and STILL ADV ( ) at the same time to set theremote control unit for use in “operation mode 1”.Alternatively, press the STOP ( g ) and STILLADV ( ) buttons at the same time to set theremote control unit for use in “operation mode 2”.When the battery in the remote control unit isreplaced, the remote control unit is set for use in“operation mode 1”.CameraIn the setup menus, OTHER FUNCTIONSscreen, REMOTE, set to 1 or 2. (Page 109)If different settings are used for the camera-recorder and remote control unit, “REMOTE” lightsin red on the viewfinder and LCD monitor.OSDCOUNTER RESET TITLESTILL ADV PAUSE STILL ADVINDEXSELECTSTOREOFF/ONP.B.DIGITALVAR.SEARCHVOL +-PB.ZOOMMENUSETITEMSTOP INDEXMULTI/P-IN-P REC A.DUBPLAY/REW FF/ZOOMDATE/TIME PHOTOSHOTSTART/STOPOperationmode Operationmode 1••
