58Recharging the built-in batteryThe camera’s internal battery saves the date andtime. “ ” appears on the screen of the viewfinderor LCD when the internal battery is running low oncharge.Do the following to recharge it.Reset the date and time when fully recharged.1 Connect the AC adapter. (Page 15)Leave the POWER switch at OFF. Leave the camera-recorder like this forabout hours.The internal battery charges during this time.Recharge the battery regularly to ensurecorrect TC and menu operations.If “ ” appears even after charging, it means thatthe internal battery must be replaced. Ask yourdealer to do this.Setting the time codeIn the setup menus, RECORDING SETUPscreen, set the following time code related items.(Page 104)TCGTC PRESET19 TC REGEN (appears when in MCR mode)In MCR mode and 1394 TC REGEN is ON, youcannot change the items shown above.••••••Specifying the time code (TC PRESET)Set TC PRESET so you can record a value of yourchoice as the initial setting for the time code to beused at the start of recording.1 Set the POWER switch to ON. On the setting menu RECORDING SETUPscreen, push the Operation lever in the eor r direction to move to TC PRESET andpress it again.RECORDING SETUPPUSH MENU TO RETURNMIC GAIN2 -50dB2CHDFREC RUN––––FRM.RATE––––OFF25M REC CH SELUB MODEUB PRESETTC MODETCGTC PRESETTIME STAMP Push the Operation lever in the r directionto move to YES and press it again.RECORDING SETUPPUSH MENU TO RETURNMIC GAIN2 -50dB2CHDFREC RUN––––YES––––OFF25M REC CH SELUB MODEUB PRESETTC MODETCGTC PRESETTIME STAMP When the screen below appears, set thetime code value.Push the Operation lever in the e or rdirection to select a time code value.TC PRESETPUSH MENU TO RETURNMONTH+/– : PUSH q / g0 0 h 0 0 m 0 0 s 0 0 fSEL : PUSH t / yCharging the built-in battery/Setting the time data
