Shooting57Counter displayYou can display a counter that indicates how muchtime has elapsed during shooting or playback.1 Press the COUNTER button.Each time you press the button, the displaychanges as follows. (Page 86)0 : 00. 00 (CAM mode only)Counter valueCLIP 0 : 00. 00(When CLIP is selected for the RECCOUNTER item on the DISPLAY SETUPscreen)The value is automatically reset at start ofshooting and the counter value appearsduring each shooting session.TC XX:XX:XX:XXTime code value (display time code framedigits in 25 frames.)UB XX XX XX XXUser informationFR --- -Frame rate (25P) and frame sequence inprogressive mode shooting.No display:Data is not displayed.Resetting the counterPress the COUNTER RESET button while thecounter is displayed.19TC preset modeWhen shooting using a multi-camera, you cansynchronously set the initial values of TC.The camera used for synchronization is theMASTER and the camera being synchronized isthe SLAVE.1 Connect a second camera with a 19cable and turn both cameras on.For connection (Page 77) Put the MASTER camera in CAMERA modeand output a video signal from the 19terminal.Set both cameras to the same recordingformat.Do the remaining steps on the SLAVE camera. Switch the SLAVE camera to MCR mode,set 19TC REGEN on the RECORDINGSETUP screen of the setup menu to OFFand then set the counter so that it showsthe TCG display.You cannot do this if you have selectedREGEN. In the setup menus, RECORDING SETUPscreen, set 19 IN PRESET to ON.(Page 105)1394TC appears on the screen.5 Stop the media.6 Press the COUNTER RESET/TC SET button.The TCG value is preset with the TC valuefrom the input 19 signal.“TC SET OK” is displayed for about 2seconds in the center of the screen.7 Reset the SLAVE camera to CAMERAmode.•••••Using the Counter
