11Chapter ManipulatingClipswithThumbnails3 UsethecursorbuttonstomovethepointertotheitemtoconfirmandpresstheSETbutton.• Use this function to check loaded metadatasettings.4 Whileviewingmetadatasettings,usethecursorbuttonstomovethepointertothedesiredoption.Then,presstheSETbutton.• A soft keyboard screen is displayed, allowing youto modify the setting.To set whether or not the uploadedmetadata is recordedSet “ON”/“OFF” in META DATA RECORD from thethumbnail menu. The factory setting is “OFF”.Selecting the USER CLIP NAME recordingmethodSelect META DATA USER CLIP NAME from the thumbnailmenu to select the recording method. Two options areavailable: TYPE1 and TYPE2.TYPE1(Factorydefaults)USER CLIP NAME to berecordedIf clip metadata has beenread in Uploaded dataIf no clip metadata has beenread in or if the setting forrecording clip metadata hasbeen turned offSame as GLOBAL CLIP ID(UMID data)TYPEUSER CLIP NAME to berecordedIf clip metadata has beenread inUploaded data + COUNTvalue*1If no clip metadata has beenread in or if the setting forrecording clip metadata hasbeen turned offSame as CLIP NAME*1 The COUNT value is indicated as a four-digit number.The COUNT value is incremented each time a new clipis captured if clip metadata has been read in and TYPE2has been selected as the recording method.The COUNT value can be reset using the followingprocedure.Select META DATA PROPERTY from the thumbnailmenu, then select USER CLIP NAME to display themenu shown below. Select “COUNT RESET” with thecursor and press the SET button to reset the COUNTvalue to 1. NOTEWhen an 8 GB or larger capacity P2 is used and the recordingsession exceeds the prescribed duration (DVCPRO HD andthe AVC-Intra100: about 5 minutes; AVC-Intra50: about 10minutes) or spans more than one P2 card, the recording willautomatically be split into separate clips. At this time, each clipwill be provided with its own COUNT value.
