1Chapter MaintenanceandInspections(Continued from the previous page)Priority WarningtypeLCD or viewfinderindication Tally lamp WarninglampAlarmtone*6Warning descriptionand recording/playbackoperationCountermeasures81394connectionerror1394 INITIAL ERROR BlinksredBlinks 4times persecondBlinks 4times persecondNoThe DVCPRO/DV cablehas become disconnectedor multiple devices areconnected.Check the cameraand deviceconnections,reconnect them ifnecessary, then turnthe power off andback on again.9 Batterynearly emptyThe last bar in the batterylevel indication blinks (Thisindication appears alsowhen MENU indicationshave been turned OFF.)Blinks 1 timeper secondBlinks 1 timeper second No The battery is near depletion.Operation continues.*5Replace the batteryas necessary.10P2 cardnearly fullyrecordedThe P2CARD level indicatorblinks.Blinks 1 timeper secondduringrecording.Blinks 1 timeper secondduringrecording.NoLess than 2 minutes is left onthe P2 cards (level indicatorshows 1 minute or less). Thiswarning appears only duringrecording.Replace or insertadditional P2 cards.*1 P2 SYSTEM ERROR cause indication• P2 MICON ERROR: The P2 microprocessor does not respond.• P2 CONTROL ERROR: A P2 recording control error has occurred.• CAM MICON ERROR: The camera microprocessor does not respond.*2 REC WARNING cause indication• CARD ERROR*: P2CARD error (* indicates the number of the slot of the card with the error.) Stops recording.• REC RAM OVERFLOW: Overflow of recording RAM. Stops recording.• PULL DOWN ERROR: 25P (30P, 24P) video pulldown error. Recording continues.• ERROR: Other recording errors (When an attempt is made to record 1000 or more clips on one P2 card.)*3 Perform either of the following procedures to cancel this warning.• Press a playback control button.• Press the THUMBNAIL button.• Remove the P2 card and insert another card.*4 Perform either of the following procedures to cancel this warning.• Press the REC button.• Press a playback control button.• Press the THUMBNAIL button.• Remove all cards.*5 When NEAR END CANCEL is set to ON, you can press the DISP/MODE CHK button to cancel the alarm.*6 When the alarm sounds, audio is not output to the camera speakers or earphones. The DISP/MODE CHK button cancelsonly the alarm tone when pressed during an alarm.
