- 147 -≥ When [DIRECT] is selected, [SECURITY TYPE] is fixed to [WPA2-AES].≥ Some settings in [BAND], [CHANNEL (2.4GHz)] and [CHANNEL (5GHz)] cannot be selecteddepending on the wireless module used.≥ For details on how to enter characters, refer to page 144.3 Touch [RETURN].4 Set [DHCP] to [SERVER].5 Touch [EXIT].6 Select the SSID of this unit from the Wi-Fi ® setup of the iPad.7 Enter the password into the iPad.8 Check the network connection.≥ When this unit is ready to be connected, will be displayed on its screen.≥ To terminate the connection, after terminating the connection on the iPad side, set [USB MODE]to [OFF].Configure the settings in this section to connect this unit and an iPad using a wireless access point.∫ Searching for wireless access points to set up a connection≥ Attach a wireless module that support this unit to the USB HOST terminal of this unit.(l 142)≥ Set [USB MODE SELECT] to [HOST]. (l 197)≥ Set [USB MODE] to [ON]. (l 197)1 Select the menu.2 Touch the wireless access point to connect to.≥ The SSIDs of wireless access points found with the search will be displayed.≥ If you touch [Refresh], you can search for wireless access points again.3 Touch [ENTER].≥ If an encryption key (password) is not set, the setup is complete.4 (If an encryption key (password) is set)Enter the password.≥ For details on how to enter characters, refer to page 144.≥ When the connection is complete, touch [Enter].5 Check the network connection.≥ When the connection is complete, is displayed on the screen of this unit.≥ To terminate the connection, after terminating the connection on the iPad side, set [USB MODE]to [OFF].: [NETWORK SETUP] # [Wireless LAN setup] # [DHCP] # [SERVER]Connecting to a wireless access point: [NETWORK SETUP] # [WIRELESS SETUP] # [SSID(SELECT)]MENUMENU