- 215 -∫ It is not a malfunction in following casesOthersTroubleshootingThe lens, the viewfinder orLCD monitor fog up.≥ This is due to condensation. This is not a malfunction. Pleaserefer to page 8.A clicking sound is heardwhen the unit is shaken.≥ This is the sound of the lens moving and is not a defect.This sound will no longer be heard when the unit is turned onand switch to Recording Mode.Object seems to be warped. ≥ Object seems to be warped slightly when the object movesacross the image very fast, but this is because the unit is usingMOS for the image sensor. This is not a malfunction.PowerProblem Check pointsThis unit cannot be turnedon.This unit does not stay onlong enough.Battery runs down quickly.≥ Charge the battery again to ensure it is sufficiently charged.(l 23)≥ In cold places, the battery using time becomes shorter.≥ The battery has a limited life. If the operating time is still tooshort even after the battery is fully charged, the battery hasworn out and needs to be replaced.This unit cannot beoperated though it isturned on.This unit does not operatenormally.≥ Remove the battery or AC adaptor, wait about 1 minute andthen reconnect the battery or AC adaptor. Then about1 minute later, turn on the unit again. (Conducting the aboveoperation while the SD card is being accessed may damagethe data on the media.)≥ If normal operation is still not restored, detach the powerconnected, and consult the dealer who you purchased thisunit from.“ERROR OCCURRED.PLEASE TURN UNIT OFF,THEN TURN ON AGAIN.”is displayed.≥ The unit has automatically detected an error. Restart the unitby turning off and on.≥ The unit will be turned off in about 1 minute if the unit is notturned off and on.≥ Repair is needed if it is repeatedly displayed even if it isrestarted. Detach the power connected, and consult thedealer who you purchased this unit from. Do not attempt torepair the unit by yourself.