- 60 -Focus TransitionYou can use Focus Transition by registering [FOCUS TRANS] to a USER button. With FocusTransition, you can shift the current focus position to a pre-registered focus position.≥ Please refer to page 82 for details about setting the USER button.To use Focus Transition, you need to register a focus position.≥ You can register up to 3 focus positions.≥ Switch to Manual Focus Mode. (l 52)1 Select the menu.2 Touch the item to which you want to register the focus position.≥ You can select the item by pressing the USER buttons 1s3.≥ The Focus Assist screen will be displayed.≥ The screen may not be magnified depending on your settings.3 Adjust the focus by rotating the focus ring.4 Touch [ENTER].≥ The icon of the item to which the focus position has been registered will be highlighted in yellow.≥ To select a different item, perform the operations in Steps 2s4.5 Touch [EXIT] to complete the setting.≥ The focus positions of the items you have set will be registered.≥ This function is not available in the following cases:j When Auto Focus is usedj During Freeze Frame (l 89)j During Super Slow Recording (l 103)j In Variable Frame Rate Mode (l 100)≥ The focus position settings are canceled in the following cases:j If you turn the unit offj If you press the THUMBNAIL buttonj If you operate the zoomj If you enable or disable Infrared Recording ModeRegistering a focus position: [RECORD SETUP] # [FOCUS TRANSITION] # [SET][1]/[2]/[3]MENU
