Notification ParametersItem DescriptionMessage Waiting Lamp If set to "Enable", the Message Waiting Lamp of your telephone turns onwhen a new message is recorded.TelephoneDevice—Device No. 1, 2, 3Specifies the Message Waiting Notification schedule for each device.The following parameters can be specified for devices 1, 2, and 3.Click Edit for the extension to change, set Device Notification forUnreceived Message to "Yes", and set program the settings, then clickOK to finish.Only Urgent MessagesSpecifies if notifications will be sent only for messages designated as urgent.Dial Number [0-9 * # T X , ;]Assigns a telephone number to Device 1, 2, or 3. You can also specify thenumber to be dialled by entering it from your telephone, allowing you to setthis feature on a case by case basis.Enter a maximum of 32 digits consisting of 0–9, , # and special codes:• ,: Dial Pause (default 1 s)• ;: Dial Pause (default 3 s)• T: Dial Tone Detection• X: Callback Number Entry Code• 0–9, , #: Dial CodeNoteIf you are using a PRI line, you may need to enter # at the end of outsidetelephone numbers.No. of RetriesSpecifies the number of times the Unified Messaging system will try to sendnotification if the device is busy or if there is no answer.Busy Delay Time (min)Specifies the time (in minutes) the Unified Messaging system waits beforeretrying message notification when the called device is busy.No Answer Delay Time (min)Specifies the time (in minutes) the Unified Messaging system waits beforeretrying message notification when the called device does not answer.334 User Manual3.2.1 User Programming
