Panasonic LP-M Series Serial Communication Manual
Also see for LP-S Series: Operation manualMaintenance GuideManual
                                                                                                                                                                                                            | |
Contents
|
37Category Name Code Function DescriptionLayout / Position adjustmentGeneral condition ALC Sets the conditions related to whole file. P.80Character condition(Shorted form)SPC Sets the condition for marking character string perline.(X/Y coordinates and laser power correction ratioonly)P.81Character conditions STC Sets the condition for marking character string perline.P.82Common characterconditionSCC Sets the marking pitch for bold character andkerning for marking proportional character.P.85Layer condition[LP-Mxxx / LP-Zxxx only]SUF Sets the layer condition for 3D marking for LP-M /LP-Z series.P.86Serial offset SEO Sets the coordinates specified for “Serial OffsetFunction” to change coordinates for each marking.P.89External offset condition OFC Sets input conditions of “External Offset Function”to switch coordinates using I/O input.P.91External offset coordinates OFS Sets offset coordinates used for “External OffsetFunction” to switch coordinates using I/O input.P.92Step & repeat condition SRC Sets the condition of “Step & Repeat” to mark thesame marking contents on multiple locations in onefile.P.93Step & repeat fine-adjustmentSRA Sets the fine adjustment of “Step & Repeat” to markthe same marking contents on multiple locations inone file.P.94Mark on/off Marking on/off by layer LMS Specifies whether mark the setting data or not byeach layer No.P.96Laser conditionLaser power LPW Sets the laser power. P.97Scan speed SSP Sets the scan speed of the laser. P.97Laser pulse cycle[LP-Mxxx / LP-Sxxx / LP-Zxxx only]MPL Sets the marking pulse cycle of laser. P.98Line width WDC Sets the width necessary to avoid crossing atmarking intersection.P.99Marking quality adjustment WTC Sets laser start point, end point, edge and curveadjustments, etc.P.100Work distance[LP-SxxxW only]WRD Sets the Work Distance. P.101ME-LPMSZ-SR-9 |
Related manuals for Panasonic LP-S Series
This manual is suitable for:
LP-S SeriesLP-M SeriesLP-M200LP-M200-CHNLP-M200-SLP-M200-S-CHNLP-M205LP-M205-CHNLP-M205-SLP-M205-S-CHNLP-M500LP-M500-CHNLP-M500-SLP-M500-S-CHNLP-M505LP-M505-CHNLP-M505-SLP-M505-S-CHNLP-MA00LP-MA00-CHNLP-MA05LP-MA05-CHNLP-MA05-SLP-MA05-S-CHNLP-MA06LP-MA06-CHNLP-MA06-SLP-MA06-S-CHNLP-S200LP-S200-CHNLP-S200-SFLP-S202LP-S202-CHNLP-S202-SFLP-S205LP-S205-CHNLP-S205-SFLP-S500LP-S500-CHNLP-S500-SFLP-S500WLP-S500W-CHNLP-S502LP-S502-CHNLP-S502-SFLP-S505LP-S505-CHNLP-S505-SFLP-S505WLP-S505W-CHNLP-Z SeriesLP-Z130LP-Z130-CHNLP-Z250LP-Z250-CHNLP-Z256LP-Z256-CHN
manualsdatabase
Your AI-powered manual search engine