59[Preparations]PreparationsAlarm ClearThe motor stop condition (trip condition) is cleared by the protective function.Start of alarm clearFinishAlarm is not cleared.Clear the alarm by resetting power.Alarm clear is finished.Keeping pressing (about 5 seconds)increases number of “ ” as shown left.Reveal execution displayKeep pressing until the LED display of the console is changed to " ".SETSSETSDo not disconnect the console cable from the servo driver during the proceeding from to. If the connector is disconnected during the time by any chance, connect the connectoragain, and restart the operation from the beginning.by pressing and .by pressing .Enter the auxiliary function mode bypressing once and four times inthe initial state of LED, and then bring inMMODEOperation with Execution DisplayOperations with Selection DisplayAfter clearing the alarm, return to Selection Display referring to “Structure of Each Mode” (Page 48 and 49).Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
