62SETSby pressing and .Reveal execution display by pressing .Keeping pressing (about 3 seconds)increases number of " " as shown left.Keep pressing until the LEDdisplay of the console is changedto " ".Initialization of EEPROM of theconsole starts.Copying parameters and modelcode from servo driver to consloestarts.Writing parameters into EEPROMof console starts.Copying has finished normally.SETS MMODEError displayIf this error display appears,start the operation from thebeginning again.To cancel the error, press.SETSDo not disconnect the console cable from the servo driver during the proceeding from to.After finishing copying, return to Selection Display referring to Structure of Each Mode (Page 48 and 49).Enter the copy mode bypressing once andfive times in the initial state ofLED, and then bring inThe number decreasesover time as 10, 9, 8, ----.Copying parameters from servo driver to console (Copy Function)Using the ConsoleOperation with Execution DisplayOperations with Selection DisplayIf the connector is disconnected during the time by any chance, connect the connector again, and restart theoperation from the beginning.If the error display appears repeatedly, that is presumably because of break of cable, disconnection ofconnector, wrong operation due to noises, or failure of EEPROM of the console.Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
