152Error MessagesA message may appear while you are operating the DVD Video Camera. If a message appears, refer tothe following table and take appropriate corrective action.Messages are arranged in alphabetical order.Message Cause & Troubleshooting Referencepage(1) Data error in a part ofimage file. Repair datanow?(2) Found error in imagefile. Repair data now?(3) Data error in allimage file. Repair alldata now?It is possible that the system cannot normally complete writing of filewhen, for example, power is turned off for some reason duringrecording or editing (deleting, dividing or combining scenes, orcreating play list). Selecting “YES” will automatically repair thevideo file, but even if “NO” is selected, the same message willappear when the DVD Video Camera is turned on next time. (Do notremove the disc while the DVD Video Camera is recognizing it:Ignoring this will deactivate the file repair function.)Follow the instructions on screen, taking note of the followingcautions:• Data may not be repaired, depending on the timing when powerwas turned off.• Data may not be repaired normally if data recorded on anotherrecorder is mixed in.• The repaired data may be different from the original recordedcontent because of partial deletion of defective portion.• Since the date/time of repair is added to the repaired data (onlythe corrected portion for partial repair), the original date/timeinformation will be lost.• Since all movies, and then all stills, are repaired, the order ofrecorded contents will be lost.(In case of message (2) (3) only)• See *1 on page 157.(1) Error has occurred.Please restart.• Error has occurred. Try to restart the DVD Video Camera usingthe following methods:(1) Turn power off, remove the battery pack or AC adaptor andreattach it, and then turn power on again.(2) Turn power off, and reinsert the disc. Then turn power on again.(3) See *3 on page 157.(4) If you have another disc available, check to see if any problemoccurs with the disc. If another disc can be used normally, theoriginal disc may be defective: Contact the disc manufacturer.If the above procedures cannot solve the problem, take note ofthe error number, and contact your dealer.Reference: “Error Code 2881” shows that the disc cannot berecognized properly.9, 42, 45, 46(2) Error has occurred.Please reinsert a disc.(3) Error has occurred.Error code No. xxxx.Please read the manual.(4) ERROR xxxx(5) DISK xxxx(1) This disc must beformatted before it canbe used by this camera.(2) Do not format thisdisc if you want to recordfrom the PC connectionterminal.(3) Format the disc now?DVD-R disc that was not initialized for camera use was inserted.47Battery pack is almostempty. Replace it.Replace with a charged battery, or use AC adaptor to power theDVD Video Camera. 42, 45Cannot combine scene. Unless consecutive scenes are selected, they cannot be combined. 106