62123Jumping to Specified Point (Go To)1 Press the MENU buttonduring playback.2 Choose the option (point youwant to go to), and then pressthe A button.Top :To go to the start, and enter playback pause.End :To go to the end of last scene, and enterplayback pause.Specify :To go to a specified point and enterplayback pause. See the following fordetails.lSpecifying the point to view1 Choose “Specify” in step 2 above, and then press theA button.The screen for specifying the point to go to willappear.2 Use the joystick to select the desired time of chosenpoint.Tilt up : To select the start.Tilt down : To select the end.Tilt left or right :–Press once: To move the cursor in 10-second units (1-still units forcard)–Hold down: To move the cursor in 1-minute units (10-still unitsfor card)3 Press the A button to enter the selection.The DVD Video Camera will go to the specified pointand enter playback pause mode.Pressing A again will start playback.To cancel the “Go To” procedure midway, press the gbutton before going to the specified point.Note :• If multiple scenes are selected using the Disc Navigationfunction or SELECT button, choosing “Top” will jump tothe beginning of selected scenes (P. 123).• When multiple scenes are selected, the total time ofselected scenes will appear in the “total recording time”display.• With card, the number of stills will appear at the “TOP”,“CURRENT”, “END” and “GO TO” indicators.• The cursor may not move at same-pitch intervals.Go T oRAMENTER RETURNEn dS p e c i f yT o pGo T oTOP END ENTER CANCELGO TO0 : 00 : 00 0 : 24 : 240 : 03 : 260 : 03 : 26TOP ENDCURRENTPosition of currentlyplayed back imageTotal recording time ofall selected scenesCursorCursor positionGo T oTOP END ENTER CANCELTOPGO TOENDCURRENT0 : 0 0 : 000 : 00 : 00 0 : 24 : 240 : 03 : 26(When the start of scene is selected)Cursor at current image position.Cursor at (GO TO) position.