| 
HL-G1 User's Manual 5.2 Serial Commands1075.2.7.7 Read CommandsFunction name Command Data Setting [unit] FormatRead measurement value RMD — -9500000 –+9500000 -950.0000 – +950.0000[mm] 2Read received light intensity RID — +00000 – +04095 +00000 – +04095+00000 Alarm OFFAlarm status ROA — +00001 Alarm ON+00000 OUT1 OFFRead OUT1 RZA — +00001 OUT1 ON+00000 OUT2 OFFRead OUT2 RZB — +00001 OUT2 ON+00000 OUT3 OFFRead OUT3 RZC — +00001 OUT3 ON1Read all outputs RMB — —Measured value, receivedlight intensity, OUT1, OUT2,OUT3, ALARM35.2.7.8 Buffering CommandsFunction name Command Data Setting [unit] Format+00000 ContinuousBuffering mode RBD WBD +00001 Trigger 1Buffering rate RBR WBR +00001 – +65535 +00001 – +65535Data amount RBC WBC +00001 – +03000 +00001 – +03000Trigger point RTP WTP +00001 – +03000 +00001 – +amount>Trigger delay RTL WTL +00001 – +65535 +00001 – +65535+00000 When TM input turns ON+00001 When value is trigger thresh-old+00002 When value is < trigger thresh-old+00003 When an alarm has occurredTrigger condition RTR WTR+00004 When an alarm has been re-leased1Trigger threshold RBL WBL -9500000 –+9500000 -950.0000 – +950.0000 [mm] 2+00000 StopBuffering opera-tion RBS WBS +00001 Start+00000 Non-buffering+00001 Wait for trigger+00002 AccumulatingRead bufferingstatus RTS —+00003 Accumulation completed1Last data point RLD — +00001 – +03000 +00001 – accumulated amount 1Rugghölzli 2CH - 5453 BusslingenTel. +41 (0)56 222 38 18Fax +41 (0)56 222 10 12mailbox@sentronic.comwww.sentronic.comProdukte, Support und ServiceSENTRONIC AG |
