HL-G1 User's Manual 4.4 Function Settings83setting range is 0 to 65535 (default setting: 0). The status during the trigger delay time is "Ac-cumulating."Trigger conditionThis function specifies under which condition the trigger is generated when "Buffering Mode"is set to "Trigger". There are 5 conditions available. The default setting is "When TM inputturns ON".1 32Stand-by Accumulation of measurement data MeasuringWhen TM input turns ON TM input ONOFFThresholdAlarmNormal operationThresholdMeasurementvalueMeasurementvalueAlarmNormal operationWhen value is ≥ trigger thresholdWhen value is < trigger thresholdWhen an alarm has occurredWhen an alarm has been released1 Data buffering starts2 Trigger is generated (trigger point)3 The amount of data to be accumulated has been reached or the sensor has received a stop command. NOTE If you select "When an alarm has occurred" as the condition, note that thesetting for "Alarm Delay" (see page 70) also becomes effective. Normally, the measurement value is kept on hold when the timing input isON. However, if "Buffering mode is set to "Trigger" and "Trigger Condition"is set to "When TM input turns ON", the measurement value will NOT bekept on hold at the moment the timing input is ON while the system is inbuffering operation.Buffering operationThis function accumulates data. You need to make all buffering settings before sending thecommand to start buffering.Reading the buffering statusUse this function for checking the accumulation status before reading out the accumulateddata.Rugghölzli 2CH - 5453 BusslingenTel. +41 (0)56 222 38 18Fax +41 (0)56 222 10 12mailbox@sentronic.comwww.sentronic.comProdukte, Support und ServiceSENTRONIC AG
