Compax3 device description C3I22T1126 192-120114 N5 C3I22T11 June 2008In this chapter you can read about:Meaning of the status LEDs - Compax3 axis controller .....................................................26Meaning of the status LEDs - Compax3MP (mains module) .............................................27Connections of Compax3S.................................................................................................28Installation instructions Compax3M....................................................................................38Compax3MP/Compax3M connections ...............................................................................40Connections of Compax3H ................................................................................................50Communication interfaces..................................................................................................60Signal interfaces.................................................................................................................65Installation and dimensions Compax3................................................................................69Safety function – safety torque off – Compax3S ................................................................78Compax3M with safety option S1: Safe torque off .............................................................873.1 Meaning of the status LEDs - Compax3 axis controllerDevice status LEDs Right LED (red) Left LED (green)Voltages missing off offDuring the booting sequence alternately flashingNo configuration present.SinCos © feedback not detected.Compax3 IEC61131-3 program not compatiblewith Compax3 Firmware.no Compax3 IEC61131-3 programFor F12: Hall signals invalid.Flashes slowly offAxis without current excitation off Flashes slowlyPower supplied to axis; commutation calibrationrunningoff Flashes quicklyAxis with current excitation off onAxis in fault status / fault present / axis energized(error reaction 1)Flashes quickly onAxis in fault status / fault present / axis deenergized(error reaction 2)on offCompax3 faulty: Please contact us. on onThe internal device status LEDs are only connected to the external housing LEDs,if the RS232 jumper at X10 is fitted to the control and the upper dummy cover isfitted.3. Compax3 device descriptionNote on Compax3H:
