Creating and modifying global configuration templates 217Model 1001MC Operations Guide 9 • Model 3088RC management1. Select a template from the Modify Configuration pop-up menu (see figure 102), then click the ModifyConfiguration button.2. Change the parameters requiring modification (see figure 103). When you have finished changing theconfiguration, click on the Submit button to save the changes.Refer to section “Applying a template” on page 217 to activate the template.Deleting a templateDo the following to delete a template:Note When a template configuration is deleted, it cannot be recovered.1. Select a template from the Delete Configuration pop-up menu (see figure 102 on page 216).2. Click the Delete Configuration button.Applying a templateThis section describes how to apply a global configuration to all Model 3088RC rack cards. Model 3088RCcards which will not be configured to the selected Global Configuration are:• Those installed in a Model 1001 rack that has the entire rack set to be protected(1)• Those that are individually set to protected(1) modeInstructions for protecting either an entire rack or individual 3088RC cards are given earlier in this chapter.The template can be applied to:• All 3088RC NTUs in ALL Model 1001 racks• All 3088RC NTUs in just ONE Model 1001 rackTo configure all Model 3088RC rack cards in all Model 1001 racksComplete the following steps.1. Starting from the HOME page, click on the Configure Cards link to display the System Level Informationpage see figure 103.
